Computer-aided manufacturing

Computer-aided manufacturing is an application of an integrated tool set which enables to perform operation without human but under their control. Computer-aided manufacturing results in output increasing, cost saving, production quality improving. Automatics makes it possible to spend less time on control of manufacturing. Yet the main objective of the Automatic Control Systems creation at hazardous production facilities is a considerate decrease of risk of emergency situations and ensuring with a high-level of industrial safety of the facility as a whole. Therefore the main objectives of the Automatic Process Control System creation are:
·  reliability growth of the equipment operation, decrease of risk of severe accidents, guarantee of high reliability and fail-safety of monitoring and control system;
· ensuring with a computer-aided good management of technological processes under normal, transient, pre-fault, emergency operating conditions;
· protection of process equipment and maintenance staff in emergency situations;
·  in-time providing the operating personnel with a comprehensive and reliable information on operation, equipment performance and technological management;
· provision the staff with the historical technical data (event logging, calculations, equipment diagnostics and so on) to analyze optimization and planning of the equipment performance and its repair;
· improvement of working conditions of the operating personnel.
The project decisions offered by our skilled specialists meet the modern safety standards and regulations. The use of modern technology of a secure data transfer enables to take the opportunity of remote obtaining of information on the system (communications protocol, trends etc.) to make operational decisions.

© LLC "Specializied Constructive Bureau" (Russia, Rostov Region, Volgodonsk), → tel: +7(8639)241828, +7(8639)249004, fax: +7(8639)241828, mail: